Trailer Setup Guide

Camping Trailer Setup Guide:

1. Site Selection
2. Set Tongue Jack
3. Disconnect car end harness, safety chains, & un-couple hitch
4. Move tow vehicle
5. Level camper - front to rear using tongue jack
6. Unlatch roof latches (4)
7. Remove crank handles from entrance door area
8. Lower stabilizer jacks until snug on the ground
9. Raise roof assembly until GREEN cable next to the door-side lift arm is taut
10. Install safety channels on door-side & off-door side lift arms
11. Install rear bunk support and pull out bunk
12. Install front bunk support and pull out bunk - install support rods.
13. Go outside and close all zippers, cover lift arms and secure bunk flaps under bunks w/stretch cords
14. Pull-out roll-out assembly - if equipped
15. Position upper galley for use
16. Set entrance door
17. Complete inside setup of bunk ends
18. Position stove for either inside or outside use
19. Setup dinette table
20. Complete service connections - shoreline/water/drain hoses
21. This now completes the SETUP process.
22. TO RETURN THE CAMPER TO TRAVEL READY, REVERSE THE ABOVE SEQUENCE...